First, the coating machine installation and use 1. Turn on the power. Note: The phase and neutral lines cannot be connected incorrectly.
2. Connect the air source to the air pipe joint on the lower side of the machine through the Φ8PU pipe.
3. A coating liquid is added to the liquid cylinder.
4. Turn on the power switch and turn on the power at this time.
5. Adjust the main engine speed according to the instructions of the main governor.
6. Open the inlet air adjustment switch and the inlet fan starts working.
7. Adjust the temperature controller to adjust the temperature to the temperature you need. At this time, if the actual temperature is lower than the set value, the heater power is turned on and the heater starts to heat up. If the actual temperature is higher than the set value, the heater power is turned off and the heater stops heating.
8. Open the gun switch and the gun starts working. Refer to the gun manual for the use of the gun.
9. After the above functions are properly adjusted, the air compressor can be turned on, and the air pressure is about 4 to 6 kg/cm3.
Second, the coating machine maintenance and maintenance 1. The lubricating oil in the gearbox and the grease in the rolling bearing inner cavity should be replaced regularly (generally no more than six months)
2. If the coating pan is not used for a long time, it should be cleaned and oiled on the surface.
3. The spray gun should be rinsed with clean water after each shift to prevent clogging. If the clogging occurs, please disassemble the spray gun according to the spray gun manual and use a fine needle to remove the muzzle residue.
4. In order to ensure that the worm gear in the gearbox meets the lubrication conditions of the transmission, the temperature rise of the cabinet during operation shall not exceed 50 °C.
5. The oil-proof seal on the shaft end of the worm should be checked and replaced regularly (not more than six months).
6. The machine must be reliably grounded and its grounding resistance should be ≤ 4Ω.
7. Do not dismantle the appliance at will.
Imported bio-based Plasticizer
Plasticizer is widely used in industrial production of polymer materials, also known as plasticizer. Any substance added to a polymer material that increases the plasticity of the polymer is called a plasticizer. Plasticizer can improve the performance of polymer materials, reduce production costs and increase production benefits. [1] is a kind of important additives, chemical products as additives commonly used in plastics, concrete, mortar, the material such as cement, gypsum, cosmetic and detergent, especially in PVC plastic products, in order to increase the plasticity of the plastic and improve the strength of the plastic, you need to add phthalic acid ester, sometimes its content can be up to 50% of the products. Weakened the effect of plasticizer mainly resin molecular valence bond between time, increase the mobility of the resin molecular bonds, reducing resin molecular crystalline, increase the plasticity resin molecules, enhanced the flexibility, easy to machining, can legally used for industrial purposes, widely exists in food packaging, cosmetics, medical equipment, water and environment. Such as plastic wrap, food packaging, toys and so on.
Imported Bio-Based Plasticizer,Bio-Based Dammar Plasticizer,Bio-Based Pvc Additives,Fatty Alcohol Plasticizers
Xingbang High Molecular Materials Co., Ltd. , https://www.chemicaladditive.com