V-type mixer is suitable for the mixing of dry powder and granular materials in pharmaceutical, chemical, food, feed, ceramic, metallurgical and other industries. Machine
It is made of stainless steel, mixed with V-shaped asymmetric material, mixed without dead angle, high uniform efficiency, reasonable structure of the machine, operator
The material is made of stainless steel and the inner wall is clean and easy to clean.
V type mixer maintenance
1. Applicable to the ambient temperature of -5oC - 40oC, relative humidity <90%, the temperature is suitable, should be placed in a ventilated, dry, clean position
.
2. It is strictly forbidden for underage children to contact the machine without authorization to avoid accidents.
3. The lubrication of the reducer is oil-immersed. The oil storage capacity must be kept on the oil mark line, and the oil quality must be kept clean. If used frequently
Change the oil every three months. When replacing, the gear unit should be removed and cleaned, and new oil should be added.
4. The control parts of the mixer electrical equipment should be kept clean and sensitive, and the fault should be repaired in time.
5. When using once or stopping work, the remaining materials in the V-shaped barrel should be taken out and the residual powder in each part of the machine should be brushed. Such as deactivation time
For a long time, the V-type mixer must be wiped clean and covered with a tarpaulin.
6. When the V-type bucket is assembled and disassembled, it should be lightly disassembled, stabilized and placed gently to avoid deformation damage.
7. Regularly inspect the machine parts 1-2 times a month. Check whether the moving parts of the power shaft, transmission, and speed reducer are flexible.
In case of wear and tear, the defects should be repaired in time so that the mixer can be used normally.
Matters needing attention when using the V-type mixer: 1. An empty-car running test machine should be used before use. The horizontal V-type should be inspected before the test run.
The consistency of all the link parts of the mixer, the amount of lubricating oil in the reducer and the integrity of the electrical equipment, then close the main switch
Enter the power supply and conduct an air trial run. 2, installation = speak mechanically placed, install the machine feet, padding, so that the machine can run freely. 3, make
Before use, add oil to each component that needs to be refueled, and then carry out no-load test operation to check whether the components are loose or not.
Normal, the machine can run normally. If there is any abnormality, please correct and debug. 4. Turn the feeding port to the top and open the feeding cover.
Feeding, the feeding amount should not exceed the specified effective volume, then close the lid, start the machine to run, if abnormalities are found on the way,
It is necessary to stop the inspection. 5. Clean the inside and outside of the hopper before each shift or replacement of mixed materials.
Porcelain Dish,Porcelain Evaporation Dishes,White Porcelain Evaporation Dishes,Round Bottom Porcelain Evaporation Dishes
Yancheng Rongtai Labware Co.,Ltd , https://www.shtestlab.com